There are only a few moving components in a HIBLOW linear air pump. Connected to the oscillating magnetic rod, the diaphragms wear and eventually rupture. The umbrella valves that are located within the casing blocks open/ close 60 times per second and wear over time. If the valves wear too much, the pump is not able to pressurize the air and your system’s performance will suffer. The degradation of the valves is gradual, so the loss in pressure may not be noticed for quite some time. It is prudent to replace the casing blocks and the diaphragms at the same time.
HIBLOW also offers a couple other rebuild kit options that include gaskets. The black base gasket seals the upper and lower housing. With years of use or in hot climates, the gasket can become brittle, and air can seep through causing a loss in pressure. The filter cover gasket can also wear. HIBLOW recommends checking the gaskets before rebuilding the pump.
Read the full article about our linear air pump rebuild kits here!
Check out our support page for videos on how to install a full rebuild kit for your HP or XP Series Pump
here: https://www.hiblow-usa.com/support/
If you have any further questions about the maintenance or repair of your pump, please do not hesitate to reach out by phone: 734-944-5032 or email: info@hiblow-usa.com.
%20HIBLOW.png)
No comments:
Post a Comment